INSTALLATION GUIDE: ULTICREATR 2X

3.1 KIT CONTENTS

The Ulticreatr 2X is composed by the following parts (fig.1):
- Ulticreatr top bracket (x1)
- aluminium bottom bracket (x1)
- nozzle (x8)
- heater block (x2)
- heater cartidge (x4)
- PT 100B sensor (x2)
- isolator (x2)
- coupler (x4)
- spring (x2)
- heatsink (x1)
- heatsink fan (x1)
- "parallel" wires (x1)
- fan bracket (x1)
- feeder assembly (x1 or x2)
- feeder motor (x1 or x2)
- secondary feeder spacer pack (x1)
- bowden tube (x2)
- tools
- bluetape
- Ulticreatr sticker
- Ulticreatr 2X firmware and installation guide

Please check that the kit includes all the content listed above.

3.2 TOOLS REQUIRED

No special tools are require to install and maintain the Ulticreatr 2X kit. All the tools required are included in the kit or already present with the Ultimaker 3D printer.

3.3 TECHNICAL KNOW-HOW REQUIRED

The Ulticreatr 2X was designed to be the most user friendly possible and therefore minimal technical knowledge is required to successfully install and use it. It is mandatory however to fully read and place great attention especially during the calibration phase.

3.4 SUPPORT

For any issues please contact your local Ulticreatr reseller or our support team via email at:
support@creatr.it

PREVIOUS     NEXT